Coil Bright is chemically Alu minium Bright chemicals.

C SHINE coil cleaner specialized to remove dirt deposits, oily and greasy deposition from Condenser and Cooling coils. C-shine is specialized cleaning Chemical for Air Conditioner  cleaning and Coil Cleaning.

C-Shine contains powerful selected alkaline additives with wetting agent and surfactant which helps to penetrates and remove dirt, grease and oil accumulation on evaporators and condenser coils quickly.

APPLICATION METHODS:

Low pressure, acid resistant tank sprayers are recommended.
Regardless of application method, avoid inhalation of mist or contact of liquid or mist with skin.

SUGGESTED INSTRUCTIONS FOR USE:

•  When handling RXSOL-16-1697-005 or any other strong chemical, be sure to wear chemical imperviousgloves,apron and splash goggles.
   
• Determine required dilution ratio for the specific application. It is recommended to start with a dilution ratio of 10:1 and increase concentration until the desired results are achieved.
   
• As with mixing all acids, place the desired amount of water into the tank and then add RXSOL-16-1697-005.
   
•   Turn off fans and allow hot coils to cool before applying.
   
• Using plain water, wet both the condenser coil as well as the area surrounding the equipment. Wetting the coil with water aids in product penetration and performance.
   
• Apply the properly diluted product to the coil surface. Whenever possible, apply solution from the outlet side of the coil. Allow product to remain on surface, normally 5-10 minutes. Do not allow product to dry on the coil. Note: In extreme cases, application may have to be repeated to achieve desired results.
• If foaming does not occur, check for extreme grease buildup which will slow cleaning process. Foaming may not occur if coil is coated or painted.
   
•   Rinse coils, tools and surrounding area thoroughly after completing the coil cleaning process

Do not allow concentrate to come in contact with skin. Avoid contact Eyes and clothing. Alu Brightener is a concentrated liquid acid formulated .
First Aid: Skin Contact: Wash area with soap and water. Rinse with a solution of vinegar and water. If irritation persists seek medical attention
Eye Contact: Flush with water for 15 minutes. Obtain medical attention
Ingestion: Drink several glasses of fruit juice. Do not induce vomiting. Obtain immediate medical attention.

Application

Immersion bath
Atleast for 2 Hrs deep COOLER PARTS in to  AIR COOLER CHEMICAL CLEANER emulsion tank. The product should be heated to approx. 50°C and agitation provided with an air line. Then drain off and flush well with water, followed by drying with an air line.

Soak method: Machine parts with stubborn carbon deposits to be cleaned is dipped into conc.Soln.of ACC then allow deposits to. Be broken down and loosened before removal, then rinse .

Circulation method
Some designs of cooler can be circulated "in situ". In this case a pump tank and pipe system is fitted permanently or connections are provided for connecting a temporary circuit. The system should be filled with AIR COOLER CHEMICAL CLEANER circulation carried out for 2 - 4 hours at a temperature of upto 50°C. After cleaning the cooler should be thoroughly flushed with fresh water and dried with an air line.

Note: Both cleaning methods benefit from heat of up to 50°C and cleaning times can be reduced or extended dependant on temperature and degree of fouling.
 

Hand spray Cleaning: By Hand spray,apply concentrate RXSOL-16-0009-210 all over the cooler coils. for good emulsification & penetration. Allow the RXSOL-16-0009-210 for a minimum of 1 hour,then use a high pressuure  water to  wash  off  the  loosened deposits. During process  always  keep drain valve  open. After satisfactory cleaning, and flushing through with fresh water, close air cooler drains.Note that during this process the engine must be  stopped.