|
Porduct Name |
|
|
Part Number |
RXSOL-19-3781-025 |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Branch : Kandla, Mumbai , Chennai, Vizag, Kolkata, UAE , OMAN , CANADA and KENYA
|
Phone |
+91 22 20871200 - 1400 |
|
Fax |
+91 22 27612100 :::AOH :0091 9821214367 |
|
Email |
rxsolchemicals@gmail.com |
|
Website |
www.rxmraine.com |
|
Chemical Name |
Cas No |
EC No |
Weight |
Formula |
|
Ethylenediaminetetraacetic acid disodium salt solution |
121-32-4 |
204-464-7 |
166,17 g/mol |
C9H10O3 |
|
Signal Word |
Warning |
|
Hazard Statements |
H319 Causes serious eye irritation. |
|
Precautionary statements |
P264 Wash skin thoroughly after handling. P280 Wear eye protection/ face protection. P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P337 + P313 If eye irritation persists: Get medical advice/ attention. |
|
Classification of the substance or mixture |
No data available |
|
Supplemental Hazard Statements |
No data available |
|
Other hazards |
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher The substance/mixture does not contain components considered to have endocrine disrupting properties according to REACH Article 57(f) or Commission Delegated regulation (EU) 2017/2100 or Commission Regulation (EU) 2018/605 at levels of 0.1% or higher. |
|
General advice |
Show this material safety data sheet to the doctor in attendance. |
|
If inhaled |
After inhalation fresh air. |
|
Eye Contact |
Rinse out with plenty of water. Remove contact lenses |
|
Swallowed |
Make victim drink water (two glasses at most). Consult doctor if feeling unwell. |
|
Skin Contact |
In case of skin contact Take off immediately all contaminated clothing. Rinse skin with water/ shower. |
|
Inhalation |
No data available |
|
Ingestion |
No data available |
|
Most important symptoms and effects, both acute and delaye |
The most important known symptoms and effects are described in the labelling (see section 2.2) and/or in section 11 |
|
Indication of any immediate medical attention and special treatment needed |
No data available |
|
Flammability |
No data available |
|
Suitable extinguishing media |
Water Foam Carbon dioxide (CO2) Dry powder |
|
Unsuitable extinguishing media |
For this substance/mixture no limitations of extinguishing agents are given |
|
Special hazards arising from the substance or mixture |
Carbon oxides Combustible. Vapors are heavier than air and may spread along floors. Forms explosive mixtures with air on intense heating. Aldrich- W246409 Page 4 of 12 The life science business of Merck operates as MilliporeSigma in the US and Canada Development of hazardous combustion gases or vapours possible in the event of fire. |
|
Further information |
Remove container from danger zone and cool with water. Suppress (knock down) gases/vapors/mists with a water spray jet. Prevent fire extinguishing water from contaminating surface water or the ground water system. |
Hazardous combustion
products |
No data available |
|
Advice for firefighters |
In the event of fire, wear self-contained breathing apparatus. |
|
Protective Equipment |
No data available |
|
Specific Hazards Arising from the Chemical |
No data available |
|
Personal precautions, protective equipment and emergency procedures |
Advice for non-emergency personnel: Do not breathe vapors, aerosols. Avoid substance contact. Ensure adequate ventilation. Keep away from heat and sources of ignition. Evacuate the danger area, observe emergency procedures, consult an expert. For personal protection see section 8. |
|
Spillage |
No data available |
|
Personal Protection |
Avoid dust formation. Avoid breathing vapors, mist or gas. For personal protection see section 8 |
|
Enviromental Precaution |
Do not let product enter drains. Risk of explosion. |
Methods and materials for
containment and cleaning |
Cover drains. Collect, bind, and pump off spills. Observe possible material restrictions (see sections 7 and 10). Take up with liquid-absorbent material (e.g. Chemizorb® ). Dispose of properly. Clean up affected area |
|
Reference to other sections |
For disposal see section 13 |
|
Advice on protection against fire and explosion |
Keep away from open flames, hot surfaces and sources of ignition.Take precautionary measures against static discharge. |
|
Incompatible materials |
No data available |
|
Hygiene measures |
Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance. For precautions see section 2.2. |
|
Advice on safe handling |
No data available |
|
Conditions for safe storage, including any incompatibilities |
No data available
|
|
Storage conditions |
Tightly closed. Dry. Light sensitive. |
|
Storage class |
Storage class (TRGS 510) 11 Combustible Solids |
|
Specific end use(s) |
Apart from the uses mentioned in section 1.2 no other specific uses are stipulated |
|
Advice on general occupational hygiene |
No data available |
|
Exposure controls |
Personal protective equipment |
|
Engineering Control |
No data available |
|
Eye/face protection |
Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses |
|
Body Protection |
Protective clothing |
|
Skin protection |
This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de). Full contact Material: Viton® Minimum layer thickness: 0,7 mm Break through time: 480 min Material tested:Vitoject® (KCL 890 / Aldrich Z677698, Size M) This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de). Splash contact Material: butyl-rubber Minimum layer thickness: 0,7 mm Break through time: 30 min Material tested:Butoject® (KCL 898) |
|
Respiratory protection |
Recommended Filter type: Filter A-(P2) The entrepeneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.
|
|
Other Protection Measure |
No data available |
|
Physical state |
Powder |
|
Colour |
White |
|
Odour |
No data available |
|
Odor Threshold |
No data available |
|
pH |
No data available |
|
Melting Point |
74 - 77 °C - lit |
|
Boiling Point |
295 °C at 1.013 hPa |
|
Flash Point |
145 °C - closed cup |
|
Evaporation Rate |
No data available |
|
Flammability (solid, gas) |
No data available |
|
Explosive limits |
No data available |
|
Upper/lower flammability or explosive limits |
No data available |
|
Autoignition temperature |
No data available |
|
Decomposition temperature |
No data available |
|
Vapour pressure |
< 0,01 hPa at 25 °C |
|
Viscosity |
No data available |
|
Density |
No data available |
|
Relative Density |
No data available |
|
Specific Gravity |
No data available |
|
Partition coefficient |
log Pow: 3,14 at 25 °C - Bioaccumulation is not expected. |
|
Explosive properties |
No data available |
|
Solubility |
No data available |
|
Ignition temperature |
No data available |
|
Particle characteristics |
No data available |
|
Reactivity |
Forms explosive mixtures with air on intense heating. A range from approx. 15 Kelvin below the flash point is to be rated as critical. The following applies in general to flammable organic substances and mixtures: in correspondingly fine distribution, when whirled up a dust explosion potential may generally be assumed |
|
Chemical stability |
The product is chemically stable under standard ambient conditions (room temperature) |
|
Possibilityof hazardous reactions |
Violent reactions possible with Oxidizing agents peroxi compounds Alkali metals Alkaline earth metals |
|
Conditions to avoid |
Strong heating. |
|
Incompatible materials |
Aluminum
|
|
Hazardous product dicomposition |
No data available |
|
Acute toxicity |
LD50 Oral - Rat - > 3.160 mg/kg (OECD Test Guideline 401) LD50 Dermal - Rat - > 2.000 mg/kg (OECD Test Guideline 402) |
|
Skin corrosion/irritation |
Skin - Human slight irritation - 48 h (Draize Test) (RTECS) |
|
Serious eye damage/irritation |
Eyes - Rabbit Eye irritation (OECD Test Guideline 405) |
|
Respiratory or skin sensitization |
- Mouse negative (OECD Test Guideline 429) |
|
Carcinogenicity |
No data available |
|
Germ cell mutagenicity |
Test Type Ames test Aldrich- W246409 Page 8 of 12 The life science business of Merck operates as MilliporeSigma in the US and Canada Salmonella typhimurium Result: negative Remarks: (National Toxicology Program) Human Test system: lymphocyte Sister chromatid exchange Mutagenicity (mammal cell test): micronucleus. negative(National Toxicology Program) Test Type: Hamster Test system: fibroblast Cytogenetic analysis |
|
Reproductive toxicity |
No data available |
|
Specific target organ toxicity-single exposure |
No data available
|
|
Additional Information |
The substance/mixture does not contain components considered to have endocrine disrupting properties according to REACH Article 57(f) or Commission Delegated regulation (EU) 2017/2100 or Commission Regulation (EU) 2018/605 at levels of 0.1% or higher. RTECS: CU6125000 To the best of our knowledge, the chemical, physical, and toxicological properties have not been thoroughly investigated |
|
Persistence and degradability |
Readily biodegradable. |
|
Toxicity to fish |
LC50 - Pimephales promelas (fathead minnow) - 87,6 mg/l - 96 h Remarks: (ECOTOX Database) |
|
Toxicity to daphnia and other aquatic invertebrates |
EC50 - Daphnia magna (Water flea) - 15,7 mg/l - 48 h (OECD Test Guideline 202) |
|
Toxicity |
No data available |
|
Toxicity to bacteria |
No data available |
|
Toxicity to algae |
Static test ErC50 - Pseudokirchneriella subcapitata - 12,3 mg/l - 72 h static test NOEC - Pseudokirchneriella subcapitata - 4,87 mg/l - 72 h |
|
Products Biodegradation |
No data available |
|
Mobility in soil |
No data available |
|
Results of PBT av PvB assessment |
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher. |
|
Endocrine disrupting properties |
The substance/mixture does not contain components considered to have endocrine disrupting properties according to REACH Article 57(f) or Commission Delegated regulation (EU) 2017/2100 or Commission Regulation (EU) 2018/605 at levels of 0.1% or higher. |
|
Other adverse effects |
No data available |
|
Product |
No data available |
|
Contaminated packaging |
No data available |
|
Waste treatment Method |
No data available |
|
UN number |
ADR/RID:- IMDG:- IATA:-
|
|
UN proper shipping name |
ADR/RID: Not dangerous goods IMDG: Not dangerous goods IATA: Not dangerous goods |
|
Transport hazard classess |
ADR/RID:- IMDG:- IATA:- |
|
Packaging group |
ADR/RID:- IMDG:- IATA:- |
|
Environmental hazards |
ADR/RID:No IMDG Marine pollutant:No IATA: No |
|
Special precautions for user |
Tunnel restriction code (D/E) |
|
Further information |
No data available |
|
Safety, health and environmental regulations/legislation specific for the substance or mixture |
This material safety data sheet complies with the requirements of Regulation (EC) No. 1907/2006 |
|
Other regulations |
Take note of Dir 94/33/EC on the protection of young people at work. |
|
Chemical Safety Assessment |
For this product a chemical safety assessment was not carried out |
|
Other Information |
The information above is believed to be accurate and represents the best information currently available to us. However, we make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and weassume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no event shall be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if Rx Marine International has been advised of the possibility of such damages.
DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable.
|
